Model (Euromap Platen Information) |
Vr-50 |
|||
---|---|---|---|---|
Injection Unit |
||||
Calculated Injection Capacity | cm3 | 60 | 80 | 102 |
Actual shot weight PS | grams | 58 | 76 | 97 |
Plasticizing capacity | kg/hr | 40 | 54 | 68 |
Injection pressure-Max | kgf/cm2 | 2635 | 2023 | 1594 |
Injection rate | cm3/sec | 89 | 116 | 147 |
Screw duameter | mm | 28 | 32 | 36 |
Screw L/D ratio | 22 | 20.5 | 18 | |
Screw speed | rpm | 10-400 | ||
Injection speed | mm/sec | 145 | ||
Suck back force | ton | 2 | ||
Screw stroke | mm | 100 | ||
Screw motor torque | kgm | 69 | ||
Nozzle stroke | mm | 245 | ||
Nozzle contact force | ton | 5 | ||
Temp. Control zones | no. | 4 | ||
Total heating wattage | Kw | 5.1 | ||
Clamping Unit |
||||
Clamping force | ton | 50 | ||
Clamping system | type | Toggle | ||
Max. Clamp stroke | mm | 270 | ||
Max. Open daylight | mm | 590 | ||
Mould close speed | mm/sec | 712 | ||
Mould open speed | mm/sec | 1100 | ||
Locatingring | mm | 100/125 | ||
Min/Max mould thickness | mm | 150-320 | ||
Platen dimensions (HxV) | mm | 446x446 | ||
Tie-Bar distance(HxV) | mm | 310x310 | ||
Tie-Bar diameter | mm | 50 | ||
Ejector stroke | mm | 60 | ||
Ejector force | ton | 3.3 | ||
General |
||||
Pump motor power | Kw | 15 | ||
Pump output vol. | l/min | 200 | ||
Cooling water regulator | l/min | 30 | ||
Oiltank capacity | litre | 230 | ||
Hydraulic sys.pressure | kgf/cm2 | 170 | ||
Machine weight | ton | 2.7 | ||
Machine dimensions (LxWxH) | cm | 386x116x222 | ||
* Specifications, technical information and dimensions are subject to charge without prior notice. |