Model (Euromap Platen Information) |
Vr-130 |
|||
---|---|---|---|---|
Injection Unit |
||||
Calculated Injection Capacity | cm3 | 180 | 200 | 265 |
Actual shot weight PS | grams | 171 | 190 | 250 |
Plasticizing capacity | kg/hr | 77 | 86 | 115 |
Injection pressure-Max | kgf/cm2 | 2180 | 1967 | 1487 |
Injection rate | cm3/sec | 132 | 147 | 196 |
Screw duameter | mm | 38 | 40 | 46 |
Screw L/D ratio | 217 | 20.5 | 18 | |
Screw speed | rpm | 10-280 | ||
Injection speed | mm/sec | 138 | ||
Suck back force | ton | 5 | ||
Screw stroke | mm | 160 | ||
Screw motor torque | kgm | 95 | ||
Nozzle stroke | mm | 340 | ||
Nozzle contact force | ton | 5 | ||
Temp. Control zones | no. | 4 | ||
Total heating wattage | Kw | 7.1 | ||
Clamping Unit |
||||
Clamping force | ton | 130 | ||
Clamping system | type | Toggle | ||
Max. Clamp stroke | mm | 400 | ||
Max. Open daylight | mm | 850 | ||
Mould close speed | mm/sec | 399 | ||
Mould open speed | mm/sec | 764 | ||
Locatingring | mm | 100/125 | ||
Min/Max mould thickness | mm | 150-450 | ||
Platen dimensions (HxV) | mm | 630x630 | ||
Tie-Bar distance(HxV) | mm | 460x460 | ||
Tie-Bar diameter | mm | 70 | ||
Ejector stroke | mm | 80 | ||
Ejector force | ton | 4.1 | ||
General |
||||
Pump motor power | Kw | 22 | ||
Pump output vol. | l/min | 330 | ||
Cooling water regulator | l/min | 30 | ||
Oiltank capacity | litre | 290 | ||
Hydraulic sys.pressure | kgf/cm2 | 170 | ||
Machine weight | ton | 5.4 | ||
Machine dimensions (LxWxH) | cm | 464x143x232 | ||
* Specifications, technical information and dimensions are subject to charge without prior notice. |