Model (Euromap Platen Information) |
Vr-80 |
|||
---|---|---|---|---|
Injection Unit |
||||
Calculated Injection Capacity | cm3 | 104 | 132 | 163 |
Actual shot weight PS | grams | 99 | 125 | 155 |
Plasticizing capacity | kg/hr | 50 | 64 | 75 |
Injection pressure-Max | kgf/cm2 | 2648 | 2092 | 1694 |
Injection rate | cm3/sec | 109 | 138 | 170 |
Screw duameter | mm | 32 | 36 | 40 |
Screw L/D ratio | 22 | 20.5 | 18 | |
Screw speed | rpm | 10-285 | ||
Injection speed | mm/sec | 125 | ||
Suck back force | ton | 1.7 | ||
Screw stroke | mm | 130 | ||
Screw motor torque | kgm | 100 | ||
Nozzle stroke | mm | 260 | ||
Nozzle contact force | ton | 5 | ||
Temp. Control zones | no. | 4 | ||
Total heating wattage | Kw | 6.15 | ||
Clamping Unit |
||||
Clamping force | ton | 80 | ||
Clamping system | type | Toggle | ||
Max. Clamp stroke | mm | 320 | ||
Max. Open daylight | mm | 670 | ||
Mould close speed | mm/sec | 470 | ||
Mould open speed | mm/sec | 665 | ||
Locatingring | mm | 100/125 | ||
Min/Max mould thickness | mm | 150-350 | ||
Platen dimensions (HxV) | mm | 510x510 | ||
Tie-Bar distance(HxV) | mm | 360x360 | ||
Tie-Bar diameter | mm | 60 | ||
Ejector stroke | mm | 80 | ||
Ejector force | ton | 4.1 | ||
General |
||||
Pump motor power | Kw | 18.5 | ||
Pump output vol. | l/min | 220 | ||
Cooling water regulator | l/min | 30 | ||
Oiltank capacity | litre | 250 | ||
Hydraulic sys.pressure | kgf/cm2 | 170 | ||
Machine weight | ton | 3.9 | ||
Machine dimensions (LxWxH) | cm | 407x124x227 | ||
* Specifications, technical information and dimensions are subject to charge without prior notice. |