Model (Euromap Platen Information) |
Vr-250 |
|||
---|---|---|---|---|
Injection Unit |
||||
Calculated Injection Capacity | cm3 | 570 | 678 | 871 |
Actual shot weight PS | grams | 541 | 644 | 827 |
Plasticizing capacity | kg/hr | 166 | 198 | 252 |
Injection pressure-Max | kgf/cm2 | 2065 | 1735 | 1351 |
Injection rate | cm3/sec | 283 | 336 | 432 |
Screw duameter | mm | 55 | 60 | 68 |
Screw L/D ratio | 22 | 20.5 | 18 | |
Screw speed | rpm | 10-200 | ||
Injection speed | mm/sec | 109 | ||
Suck back force | ton | 8.4 | ||
Screw stroke | mm | 240 | ||
Screw motor torque | kgm | 210 | ||
Nozzle stroke | mm | 450 | ||
Nozzle contact force | ton | 7.9 | ||
Temp. Control zones | no. | 4 | ||
Total heating wattage | Kw | 15.5 | ||
Clamping Unit |
||||
Clamping force | ton | 250 | ||
Clamping system | type | Toggle | ||
Max. Clamp stroke | mm | 580 | ||
Max. Open daylight | mm | 1130 | ||
Mould close speed | mm/sec | 445 | ||
Mould open speed | mm/sec | 834 | ||
Locatingring | mm | 150/160 | ||
Min/Max mould thickness | mm | 250-550 | ||
Platen dimensions (HxV) | mm | 820x820 | ||
Tie-Bar distance(HxV) | mm | 610x610 | ||
Tie-Bar diameter | mm | 100 | ||
Ejector stroke | mm | 170 | ||
Ejector force | ton | 8.5 | ||
General |
||||
Pump motor power | Kw | 37 | ||
Pump output vol. | l/min | 450 | ||
Cooling water regulator | l/min | 50 | ||
Oiltank capacity | litre | 400 | ||
Hydraulic sys.pressure | kgf/cm2 | 170 | ||
Machine weight | ton | 9.6 | ||
Machine dimensions (LxWxH) | cm | 624x176x249 | ||
* Specifications, technical information and dimensions are subject to charge without prior notice. |