Model (Euromap Platen Information) |
Vr-180 |
|||
---|---|---|---|---|
Injection Unit |
||||
Calculated Injection Capacity | cm3 | 332 | 392 | 475 |
Actual shot weight PS | grams | 315 | 372 | 451 |
Plasticizing capacity | kg/hr | 111 | 154 | 191 |
Injection pressure-Max | kgf/cm2 | 2250 | 1904 | 1574 |
Injection rate | cm3/sec | 152 | 181 | 217 |
Screw duameter | mm | 46 | 50 | 55 |
Screw L/D ratio | 22 | 20 | 18 | |
Screw speed | rpm | 10-200 | ||
Injection speed | mm/sec | 91 | ||
Suck back force | ton | 5 | ||
Screw stroke | mm | 200 | ||
Screw motor torque | kgm | 160 | ||
Nozzle stroke | mm | 380 | ||
Nozzle contact force | ton | 5 | ||
Temp. Control zones | no. | 4 | ||
Total heating wattage | Kw | 11.1 | ||
Clamping Unit |
||||
Clamping force | ton | 180 | ||
Clamping system | type | Toggle | ||
Max. Clamp stroke | mm | 470 | ||
Max. Open daylight | mm | 970 | ||
Mould close speed | mm/sec | 356 | ||
Mould open speed | mm/sec | 707 | ||
Locatingring | mm | 100/125 | ||
Min/Max mould thickness | mm | 200-500 | ||
Platen dimensions (HxV) | mm | 720x720 | ||
Tie-Bar distance(HxV) | mm | 510x510 | ||
Tie-Bar diameter | mm | 85 | ||
Ejector stroke | mm | 140 | ||
Ejector force | ton | 5.6 | ||
General |
||||
Pump motor power | Kw | 22 | ||
Pump output vol. | l/min | 330 | ||
Cooling water regulator | l/min | 30 | ||
Oiltank capacity | litre | 290 | ||
Hydraulic sys.pressure | kgf/cm2 | 170 | ||
Machine weight | ton | 6.2 | ||
Machine dimensions (LxWxH) | cm | 553x148x248 | ||
* Specifications, technical information and dimensions are subject to charge without prior notice. |